Sammic CA-301 Mode D'emploi page 9

"Machine connected to mains" warning light
(1) should flash. If it does not the keypad may
be malfunctioning.
The machine was on and stopped without
pressing any key. If the machine is on, without
pressing the pusher plate (L) the machine stops
automatically after 30 minutes.
Note: In the CA-601 there is no pin, therefore
after 30 minutes the machine stops auto-
matically. To restart the machine simply
press "On" (3).
NOTE: The electronic board has the follo-
wing lights and indicators:
- Power: Lights up when there is voltage in the
board.
FIG. 1
3
4
- SEG: Lights up if all the safety devices are
closed.
- RL1, RL2, RL3: They light up when the
corresponding relay closes its contact.
- Switch SW1: Position OFF cutter 1 speed.
Position ON cutter 2 speeds.
- Fus1-Var1: The board has a fuse and a pro-
tection varistor.
The motor does not start when the pusher plate
is pressed down:
- If the pusher plate (L) is left open for more
than 30 seconds, press "Start" (3) again to
reset the machine.
- In the CA-301 machine the hopper might be
too full and the pusher plate does not activate
the microswitch. Empty part of the hopper and
try again.
1 2
If the machine makes too much noise or the
disc (A) rubs against any part, the main axle
bearings are probably damaged.
OTHER IMPORTANT INFORMATION
- This machine is not designed for use by peo-
ple (including children) with reduced physical,
sensory or mental capabilities or lacking the
necessary experience or knowledge, unless
they have received supervision or instructions
from a health and safety expert.
- This machine must not be left running unsu-
pervised.
5 1 6
3 4 7
9
EN