Troubleshooting; Error Checklist - Sennheiser evolution wireless Série Notice D'emploi

7

Troubleshooting

Error checklist

Problem
No operation indication
No RF signal
RF signal available
but no audio signal
Audio signal has a high
level of background noise
Audio signal distorted
If problems occur that are not listed in the above table, please contact
your local Sennheiser agent for assistence.
Possible cause
Batteries are flat
No mains connection
Transmission frequency is not the
same as the receiving frequency
Transmitter is out of range
Transmitter is muted ("MUTE")
Receiver's squelch threshold adjusted
too high
SKP 500 plug-on transmitter does not
supply phantom powering to conden-
ser microphone (u "Preparing the
devices for use")
Transmitter sensitivity adjusted too
low
Receiver's AF output level adjusted
too low
Transmitter sensitivity adjusted too
high
Receiver's AF output level
adjusted too high
83