Sennheiser evolution wireless Série Notice D'emploi page 80

PHAnto Switching the phantom powering on/off (SKP 500 only)
The SKP 500 transmitter can supply condenser microphones with 48 V
phantom powering (P 48). Please note: Dynamic microphones can be operated
in phantom powering mode without harm. However, if no condenser
microphone module is being used, you should switch off the phantom
powering. With the phantom powering switched on, the operating time of
the battery will be reduced to approx. 5 hours.
The phantom powering can be switched on or off via the operating menu:
Select the "PHAnto" menu by pressing the
appears on the display; after a short pause the current setting is
displayed.
Press the button to switch the phantom powering on – if you press
the button, the phantom powering is switched off. The new setting
– i.e. "ON" or "OFF" – starts flashing on the display.
Press the SET button to return to the top menu level. The display
then switches back to the standard display.
SET button until "PHAnto"
77