Sennheiser evolution wireless Série Notice D'emploi page 59

56
Mounting the rubber feet
To ensure that the receiver cannot slip on the surface on which it is placed,
four self-adhesive soft rubber feet are supplied. These feet are stuck into the
recesses on the bottom side of the receiver. (N.B.: Do not use these feet if
rackmounting the receiver).
Ensure that the recesses are clean and free from grease before fixing
the feet.
Attention!
Some furniture surfaces have been treated with varnish, polish or
synthetics which might cause stains when they come into contact with
other synthetics. Despite a thorough testing of the synthetics used by
us, we cannot rule out the possibility of discolouration, since we don't
know your furniture.
Connecting the antennas
The EM 500 receiver can be used with either telescopic antennas (supplied)
or remote antennas (available as accessories).
The supplied telescopic antennas can be mounted quickly and easily to the
rear of the receiver and are suitable for all applications where – good reception
conditions provided – a wireless transmission system is to be used without a
large amount of installation work.
Connect the telescopic antennas to BNC sockets
rear of the receiver. Pull the antennas out and align them upwards in
a V-shape.
If the receiver position is not the best antenna position for optimum reception,
you can use remote antennas. These are available as accessories.
Connecting the mains unit
Insert the DC connector on the power supply output cable into socket
at the rear of the receiver.
Pass the cable through the cable grip
Connecting the amplifier/mixing console
Connect the amplifier/mixing console either
– to the XLR-3M socket
– to the 1 / " (6.3 mm) jack socket
4
For information on balanced and unbalanced connection, please refer
to the chapter "9 Overview".
and
.
or
.
at the