Fitting
How to proceed:
R
Before fitting the filter drum check that the drum seal is undamaged and correctly positioned. Lubricate
the seal with the supplied grease. Replace the drum seal if damaged.
1. Fitting a new drum seal: Ensure that the recess in the drum seal is at the top.
2. Ensure that the separating plate is completely seated in the groove of the drum seal.
► Continue to assemble in the reverse order.
8.8
Cleaning the rinsing pump
N O T E
It is often possible to remove soiling from the rinsing device and rinsing pump by cleaning the rinsing
device without the nozzle/nozzles. (→ Cleaning the rinsing device)
► Remove the nozzle/nozzles for cleaning so that the dirt particles are flushed out.
Remove the inner cover to allow work to be carried out on the rinsing pump. ( Replacing the foam filters)
How to proceed:
S
1. Undo the fastening device. To do this, unhook both rubber straps.
2. Lift the rinsing pump, remove the rubber ring and filter sock.
– Clean all parts in clean water.
8.9
Replacing the rinsing pump
Remove the inner cover to allow work to be carried out on the rinsing pump. ( Replacing the foam filters)
How to proceed:
T
1. Undo the fastening device. To do this, unhook both rubber straps.
2. Loosen the union nut and disconnect the hose.
3. Take out the rinsing pump and replace.
– Disconnect the connection cable from the cable harness.
4. Fit the rinsing pump in the reverse order.
- EN -
63