Cleaning The Pump - Oase Filtral UVC 700 Notice D'emploi

- English -
Filtral UVC 1200 (cont.)
3. Remove the UVC clarifying unit including pump (D), foam
filters (E, F), bio surface elements (G) and gravel bags (H).
●
If an air pump was installed: put the aeration stone (I) to the
side.
● Clean the bottom strainer casing (B) and the top strainer
casing (C) with clear water using a brush.
● Wash out foam filters (E, F), bio-surface elements (G) and the
gravel bag (H) under running water.
● Do not use chemical cleaning agents as they would kill the
micro-organisms in the different filter media. At the beginning,
this entails a reduced filter capacity.

Cleaning the pump

Filtral UVC 700 / 1200
1. Unscrew the pump (A) from the UVC water
housing (B). Remove the pump and place the
UVC water housing to the side.
2. Unscrew the pump lid (C) by turning counter-
clockwise (bayonet closure) and remove rotor (D).
3. Clean all pump components using clean water
and a brush. After cleaning the pump, reassemble
the pump in the reverse order.
● If you intend on cleaning the UVC water housing
do not screw the pump back into the housing.
Opening and cleaning the UVC water housing
Filtral UVC 700 / 1200
NOTE
For safety reasons, the UVC lamp can only be switched on when the unit
head has been correctly fitted into the casing
● The UVC water housing (A) is fastened to the unit head (B) by means
of a bayonet closure.
1. Press on the engagement lug (C) at the unit head (B), turn the UVC
water housing (A) counter-clockwise and carefully pull it off the unit
head (B).
2. Clean the UVC water housing (A) under running water. Check the
quartz glass for damage and clean its outer face with a moist cloth.
3.
E
G
H
1.
B
A
A
D
F
B
2.
A
A
C
F
I
C
D
C
B
8