Volume Adjustment - LaserLiner AutoControl-Master ACM Mode D'emploi

Working with the SensoCommander
Control panel
14
15
16
Note: The laser receiver has two tolerance settings: Precision and free-hand
setting. On the SensoCommander 120, the settings are indicated by LEDs:
precision setting: green; free-hand setting: orange. On the SensoCommander Pro,
changeover between the settings is done by the
Precision range:
Mode with smaller
tolerance for precise
alignment (e.g. with
measuring staff, > 10 m).
The SensoCommander can recognise the laser beam over
long distances. Move the SensoCommander up and
down through the laser beam until the middle display
appears. Now mark the height on the all-round marking
groove. The Spotlite additionally shows the measured
height (not on SensoCommander CoolBlue).
Universal mount:
The receiver can be installed on levelling staffs with the aid of
the universal mount. To do this, insert the universal mount
into the laser receiver and secure on the levelling staff with
the aid of the screw. To release the universal mount from the
laser receiver, turn the quick release lock in the direction of the
arrow.
ENGLISH
14 Spot mode / rotary mode
15 Scan mode
17
16 Hand receiver mode
18
17 Position
18 Speed / Volume / Angle range
Free-hand range:
Mode with greater
tolerance for less precise
alignment by hand
(< 50 m).
Instruction Manual
button.
Volume
adjustment:
1
2
21