Zodiac
AquaPure
®
Red
Figure 16. Connecting Cell leads
16. Attach the terminal cap.
17. Plug the pod connector into the power pack (see
Figure 17).
Pod Connector
Figure 17. Pod Connector
18. Attach one end of the bonding wire to the
bonding lug located on the bottom of the chassis
backplate on the power pack (see Figures 18
and 19). Attach the second end to a common
bonding point such as the pool pump or heater.
Make sure to refer to the pump or heater manual
for the location of the bonding lug connection
prior to making this connection. See Figure 20
for examples of bonding lug locations. Do not
use the power pack as the common bonding
point. There should only be one bonding
connection to the power pack. Each piece of
non-related pool equipment requiring a ground
should also be bonded to the common, approved
bonding point.
19. Plug the power pack into the electrical outlet.
Turn the power pack on.
Ei Series APURE35PLGC
®
Black
Red
Blue
|
Installation and Operation Manual
Figure 18. Bonding Wire
Bonding Wire
Figure 19. Bonding Wire Attached to Power Pack
Pump
Figure 20. Bonding lug locations
3.4
Bypass Plumbing instructions: if
Flow Rate Exceeds 348 L/min (92
GPM)
If flow rate exceeds 348 L/min (92 gpm), the cell must be
plumbed on bypass otherwise it may result in property
damage, personal injury, or death.
English
Bonding
Lug
heater
Bonding Wire
WARning
Page 15