Declaration Of Compliance; Gas Technical Data Table; Electrical Technical Data Table; Installation - Lotus CF4-68GEM Instructions Pour L'installation Et L'emploi

Table des Matières

Les langues disponibles

The manufacturer declares that the appliances are compliant with the prescriptions of the EEC norm 90/396 for the gas

part and with norm 73/23 for the electric part. The installation must be done observing the norms in force particularly

concerning room ventilation and discharging gas emissions.

N.B.: The manufacturer declines any responsibility for direct or indirect damage caused by improper or incorrect

installation, alterations, maintenance or use of the appliance, as in all the other cases considered in the items of our sales

conditions.

MODEL

CF4-68GEM

CF6-610GEM

CFM4-66GEM

CFM4-68GEM

CFM6-610GEM

MODEL

DIMENSIONS cm

80x60x90h

CF4-68GEM

CF6-610GEM

100x60x90h

60x60x90h

CFM4-66GEM

80x60x90h

CFM4-68GEM

CFM6-610GEM

100x60x90h

•

The operations for installing, conversions for use with other types of gas and starting up must be done only by

qualified personnel whose qualifications comply with the norms in force.

•

Gas installations, the electrical connections and the rooms in which the appliances are installed must comply with

the norms in force in the Country in which the installation is carried out; above all, the appliance must be installed

in a well ventilated room, preferably under an extractor hood, so as to ensure the complete extraction of gas

emissions which are formed during combustion. The air necessary for combustion is 2m3 /h per kW of power

installed.

Attention! In accordance with international rules, when connecting the appliance, an automatic device enabling the

disconnection of all contacts from the mains, must be installed above it; this device must have a contacts opening of at

least 3 mm.

Make sure that the air intake into the room where the appliance is installed is sufficient for an adequate change of air, as

specified by regulations in effect.

The appliances installed in buildings open to the public must satisfy the following requirements.

Installation rules

The installation and maintenance of the appliance must be done according to the correct procedures and regulation texts

in use, particularly:

• safety standards for the prevention of fire and panic.

Connection and installation of appliance, ventilation and exhaust removal systems, shall be done according to the

Manufacturer's instructions and by qualified technicians and according to the regulations in effect. The electric wiring

shall conform to the regulations in effect. All fire prevention codes shall be observed.

a) General indications (Rules valid for GB only)

- For all appliances:

Gas safety Regulations, 1984; Health and safety at Work Act, 1974 Codes of Practice, BS 8173, 1982, The Building

Regulations 1985; The Building Standards Regulations, 1981, the IEE Regulations and the by-laws of the local Water

Undertaking.

The local gas Region or LPG supplier and the local authority and the relevant recommendation of the British Standards

(latest editions) concerned.