Declaration Of Compliance; Technical Data Table; Installation; Checking For Correct Ventilation - Lotus PA-78G Instructions Pour L'installation Et L'emploi

Table des Matières

Les langues disponibles

The manufacturer declares that the appliances are compliant with the prescriptions of the EEC norm 2009/142 for the

gas part. The installation must be done observing the norms in force particularly concerning room ventilation and

discharging gas emissions.

N.B.: The manufacturer declines any responsibility for direct or indirect damage caused by improper or incorrect

installation, alterations, maintenance or use of the appliance, as in all the other cases considered in the items of our sales

conditions.

MODEL

PA-78G

PAT-78G

PAF-78G

•

The operations for installing, conversions for use with other types of gas and starting up must be done only by

qualified personnel whose qualifications comply with the norms in force.

•

Gas installations, the electrical connections and the rooms in which the appliances are installed must comply with

the norms in force in the Country in which the installation is carried out; above all, the appliance must be installed

in a well ventilated room, preferably under an extractor hood, so as to ensure the complete extraction of gas

emissions which are formed during combustion. The air necessary for combustion is 2m3 /h per kW of power

installed.

Make sure that the air intake into the room where the appliance is installed is sufficient for an adequate change of air, as

specified by regulations in effect.

The appliances installed in buildings open to the public must satisfy the following requirements.

Installation rules

The installation and maintenance of the appliance must be done according to the correct procedures and regulation

texts in use, particularly:

• safety standards for the prevention of fire and panic.

Connection and installation of appliance, ventilation and exhaust removal systems, shall be done according to the

Manufacturer's instructions and by qualified technicians and according to the regulations in effect. The electric wiring

shall conform to the regulations in effect. All fire prevention codes shall be observed.

a) General indications (Rules valid for GB only)

- For all appliances:

Gas safety Regulations, 1984; Health and safety at Work Act, 1974 Codes of Practice, BS 8173, 1982, The Building

Regulations 1985; The Building Standards Regulations, 1981, the IEE Regulations and the by-laws of the local Water

Undertaking.

The local gas Region or LPG supplier and the local authority and the relevant recommendation of the British Standards

(latest editions) concerned.

The installation, transformation and repair of appliances for professional kitchens as well as removal due to

malfunction,

and the supply of gas, may be made only by means of a maintenance contract stipulated with an authorised sales office

and in observance of technical regulations.

The appliance can be installed by itself or in a series side by side with appliances produced by us. There must be a

minimum distance of at least 10 cm between the appliance and the sides of the nearby cabinets made of inflammable

material. Take suitable measures to guarantee thermal insulation of the inflammable sides, such as, for example, the

installation of protection against radiation. The appliances must be installed in a suitable manner, observing the safety

standards. The small feet are adjustable to level the appliance.

The gas connection must be done with steel or copper pipes, or otherwise with flexible steel pipes in compliance with

the national norms, if any exist. Each appliance must be provided with a cut-off cock for rapid interruption of the gas