Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.0 Maintenance and Service
Maintenance and Cleaning
► Before any work on the machine itself, pull
the mains plug.
► For safe and proper working, always keep
the machine and ventilation slots clean.
The machine must then be sent to an after-sales
service agent. Addresses are listed in the Section
"After- sales service and customer assistance".
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service cen-
tre for WOLFF power tools.
In all correspondence and spare parts orders, plea-
se always include the 10-digit article number speci-
fied on the type plate of the machine.
7.0 Troubleshooting
Fault Possible cause
The machine does not start
Power supply interrupted
Defective fuse
Defective cable
Defective plug
Higher exertion of force
Cutting blade dull
required while working
Impact stop out after a
Overload: temperature
certain time
protection switches off
8.0 Disposal information
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools
into household waste!
According the European Guideline
2002/96/EC for Waste Electrical
and Electronic Equipment and its implementation into
national right, power tools that are no longer usable
must be collected separately and disposed
of in an environmentally correct manner.
Subject to change without notice.
01/2014
ROBO-STRIPPER #073888
Remedy
Contact
electrician
for repair and/or
replace parts
Replace
cutting blade
or resharpen
Cool down machine
27
Publicité
Table des Matières
