Maintenance - WOLFF JIVE Traduction Du Mode D'emploi Original

3.3 Restriction of use
The Grinding machine JIVE is exclusively for wet-cleaning and
polishing of resilient and textile floor coverings, and for grinding
pavement and levelling compounds in dry environments. It should
not be used for any other purpose.
3.4 Genuine Spare Parts
Spare parts and accessories are manufactured uniquely for the
Grinding machine JIVE. It must be emphasized that parts obtained
from unauthorized sources must not be used.
Wolff cannot be held responsible for the performance of or any
damage arising from the use of machines in which
genuine spare parts have not been used.
This is particularly important with mounting discs, discs and
brushes.

4.0 Maintenance

The Grinding machine JIVE is virtually maintenance-free. The
roller bearings and gear box need not to be lubricated.
Mounting and changing the paper bags of the vacuum unit
The vacuum unit can be used with paper bags, or, with the
enclosed textile bag.
release and pull the cover of the vacuum unit upwards
insert paper bag
remount the cover
5.0 Use
Getting started
The grinding machine JIVE is shipped in 2 separate boxes.
Mount the handle with 4 screws (Pos.16) to the machine.
Connect the power cord of the handle with the machine.
Assembly of mounting discs, pads and brushes
Lay the machine down on the handle. Thus the support of the
discs is accessible. Put the mounting disc on the actuation and
lock it by turning anti-clockwise.
Assemblyof the vacuum unit
Assemble the vacuum unit with2 supports to the handle.
insert lower connector into the plastic mount.
lock the upper connector by shifting the upper plastic
mounting down.
The upper plastic mounting can be shiftet by loosening the
screws.
01/2010 Einscheibenschleifmaschine JIVE, #056363
Wolff cannot be held responsible for any damage or
loss caused by incorrect use Correct use also includes
to take care of all directions from the operating
manual and
the execution of maintenance and service.
2
4
1
Pos. 16
3
4
13