Maintenance; Use - WOLFF RUMBA Traduction Du Mode D'emploi Original

WOLFF cannot be held responsible for any damage or
loss caused by incorrect use Correct use also includes
to take care of all directions from the operating
manual and
the execution of maintenance and service.
03/2010
3.3 Restriction of use
The Polishing machine RUMBA is exclusively for wet-cleaning
and polishing of resilient and textile floor coverings, and for
grinding and milling pavement and levelling compounds in dry
environments. It should not be used for any other purpose.
WOLFF cannot be held responsible for any damage or loss
caused by incorrect use.
3.4 Genuine Spare Parts
Spare parts and accessories are manufactured uniquely for the
Polishing machine RUMBA. It must be emphasized that parts
obtained from unauthorized sources must not be used.
WOLFF cannot be held responsible for the performance of or
any damage arising from the use of machines in which genuine
spare parts have not been used.
This is particularly important with milling discs.

4.0 Maintenance

The Polishing machine RUMBA is virtually maintenance-free.
The roller bearings and gear box need not to be lubricated.

5.0 Use

5.1 Getting started
The polishing machine RUMBA is shipped in 2 separate boxes.
Mount the handle with 4 screws, safety washers and nuts to the
machine.
Connect the power cord of the handle with the machine.
Note:
Mount the handle with the cable entry (5) backwards (towards
the user). Otherwise the machine will not operate.
5.2 Assembly of mounting discs, pads and brushes
Lay the machine down on the handle. Thus the support of the
discs is accessible.
Put the mounting disc on the actuation and lock it by turning
anti-clockwise.
Poliermaschine RUMBA (230 V), #013509
10