R&G STREET 500 Mode D'emploi page 10

FITTING INSTRUCTIONS

To fit the R&G tail tidy, remove the seat by removing the bolt arrowed in picture 1. The seat needs
to be fed through the grab strap in order to slide the seat rearward to remove from the front
mounts.

With the seat off, remove the two bolts on both sides of the rear cowl and then the metal cover and
framework underneath can be removed from the bike, as shown in pictures 3 & 4.

Remove the rear cowl from the bike, as shown in picture 5. Disconnect the tail light & indicator
wiring (it is advisable to mark on the connectors which pair match, to aid re-fitment).

Remove the two small bolts on either side of the bike that mount the plastic OEM licence plate
hanger to the frame, as shown in picture 6.

Remove the remaining bolt at the rear that locates through the frame and into the clip on the OEM
licence plate hanger, as shown in picture 7.

The OEM licence plate hanger can now be slid forward off this clip and gently lowered away from
the bike, as shown in picture 8.

Remove the clip from the rear mount on the frame, as shown in picture 9.

Take the R&G mounting bracket (item 9 – TB0188 Part 1) and offer it up to the bike as shown in
pictures 10, 11 & 12 (ensuring the cut-out on the rear face is upwards). Fit one M6 x 16mm long
button head bolt, M6 washer & M6 nyloc nut through the mounting hole on both sides of the bike
with the mounting bracket on the inside of the frame, as shown.

Take the R&G Licence Plate Bracket and offer it into position as shown in picture 13. Use the
remaining two M6 x 16mm long button head bolts, M6 washer and M6 nyloc nuts to secure onto
the mounting bracket as shown in picture 13.

The upper mounting tab on the licence plate bracket should sit somewhere near to the mounting
bracket on the frame, as shown in picture 14.

Take the R&G Tail Light (item 1 – LA0003) and fit the shroud (item 2) as shown in picture 15.

Take this light assembly and fit it to the licence plate bracket, as shown in picture 16, before fitting
the washer and nuts on the rear and tightening.
If fitting OEM Indicators

Remove the OEM indicators from the OEM licence plate hanger by firstly removing the four
screws that secure the cable clips and rear light in place, to allow the cables to be released, as
arrowed in pictures 17 & 18.

Remove the bolt that secures each indicator in place, as shown in picture 19.

In order to get the indicator free from the licence plate hanger and the connector through the hole,
the connector must be removed from the wiring. To do this, use a small electrical screwdriver
inside the connector and push the small prong on each of the wiring ends to one side, whilst gently
pulling the wiring from the rear of the connector. The wires should come out of the connector, one
at a time, as shown in pictures 20, 21, 22 & 23. (Its advisable to mark on the connector which wire
goes either side).

Pull the wiring through the hole of the OEM licence plate hanger and before fitting the indicators
to the R&G tail tidy, re-fit the connectors onto the wires by simply pushing them into the correct
slots.

Fit the indicators to the tail tidy indicator mounts, with the wiring fitting through the hole with the
slot, and re-fit the original bolt to secure in place, as shown in pictures 24 & 25.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G Racing
www.rg-racing.com Email: info@rg-racing.com