Nomenclature And Functions; Front; Lcd Screen - Toa WT-D5800 Mode D'emploi

5. NOMeNclaTUre aND FUNcTiONs

[Front]

2 3
AF PEAK
ANT A
ANT B
PC
1. Power switch
Pushing this switch to the ON position ( )
turns the power ON, while pushing it to the
OFF position ( ) turns the power OFF.
2. UsB connector for Pc use
Used to connect the unit to a PC with the
installed software.
3. aF peak indicator
Lights when the output level reaches the
point of about 3 dB below the clipping level.
4. reception indicators
Depending on the state of reception, the
indicator's lit or unlit state will be determined
as follows.
When being received normally*
When abnormal reception occurs*
When reception does not occur
* While receiving radio waves and when audio
1
output is in a ready state
* While receiving radio waves, in the state
2
when audio output does not occur

5. lcD screen

The status of each function is displayed,
such as for reception frequency, security
setting, and battery level, etc.
(a) (b)
A – 1
(d)
R F A
B
(e)
6
4 5
μV 10 30 100 300 500
DIGITAL WIRELESS RECEIVER WT-D5800
Lit
1
(green)
Lit (red)
2
Unlit
(c)
8 8 8 . 8 2 5 M H z
FBS
A F
(f) (g)
6
SET
dB -36 -27 -18 -9 0
(a) Bank number
(b) Channel number
(c) Frequency
(d) Lock icon
Displayed when the Encryption function
is enabled.
(e) RF meters A and B
Indicate the received radio wave strength
in meters.
"A" indicates the strength of radio waves
received by the 'A' system antenna, while
"B" indicates the radio wave strength of
the 'B' system antenna.
(f) FBS indication
Displayed when the FBS function is
enabled.
(g) AF meter
Indicates the received microphone audio
signal level in meters.
(h) Remaining battery capacity indicator
Indicates the microphone's remaining
battery capacity.
6. set key
Brings the unit in setting mode when pressed
for about 1 second in normal operating state.
In setting mode, pressing this key determines
the selected setting item and registers its
(h) contents.
7 8
0 10
VOLUME
: Battery power is full charge.
: B attery power depletion has
started.
: B attery power is almost depleted,
and battery replacement
required.
1
POWER
is