Operation - Toa WT-D5800 Mode D'emploi

9. OPeraTiON

WT-D5800
AF PEAK
ANT A
ANT B
PC
DIGITAL WIRELESS RECEIVER WT-D5800
step 1. Turn the power on.
The LCD screen comes to display the receiving frequency and RF/AF levels.
step 2. Confirm that the wireless microphone and this unit are identical in the bank and channel
number.
step 3. Set the wireless microphone power switch to the ON position.
The reception indicator lights green when the receiver receives the same frequency signal.
step 4. Adjust the volume control.
The output level increases as the control is rotated clockwise, and decreases as rotated
counterclockwise.
Tip
The knob is initially set at the two o'clock position, thus make adjustment to the desired
volume. When the AF peak indicator is lit at all times, lower the volume.
step 5. After the usage of the unit, turn OFF the power and the wireless microphone power switch.
Note
Depending on the setting of the contact output, when you set the wireless microphone power switch
to ON, there is the case that the external device connected to the unit may be operational with the
contact output from the unit.
2
μV 10 30 100 300 500 dB -36 -27 -18 -9 0
4
SET
0 10
VOLUME
1
ON
POWER
OFF
WM-D5200
3
23