Toa WT-D5800 Mode D'emploi page 20

step 3. Perform TYPE setting.
3-1. Select "TYPE" with the Up or Down key.
3-2. Press the Set key, and the LCD screen displays the current setting.
3-3. Select "LEVEL" or "ONE-SHOT" with the Up or Down key.
3-4. Press the Set key to resister the setting.
This terminates the TYPE setting, and the display returns to the "TYPE" indication.
Note
When leaving the original TYPE setting unchanged, select "EXIT" with Up or Down key and
press the Set key. Then, the display returns to the "TYPE" indication.
step 4. Perform TRIGGER setting.
4-1. Select "TRIGGER" with the Up or Down key.
4-2. Press the Set key, and the LCD screen displays the current setting.
4-3. Select "RF ON" or "BATT ALARM" with the Up or Down key.
4-4. Press the Set key to resister the setting.
This terminates the TRIGGER setting, and the display returns to the "TRIGGER" indication.
Note
When leaving the original TRIGGER setting unchanged, select "EXIT" with Up or Down key
and press the Set key. Then, the display returns to the "TRIGGER" indication.
step 5. Select "EXIT" with the Up or Down key and press the Set key.
The display returns to the "CONTACT OUT" indication.
step 6. When any other setting is not needed, select "EXIT" with the Up or Down key and press the
Set key.
The unit returns to the normal operating state.
Note
When another setting is needed, select the necessary setting item with the Up or Down key
and press the Set key.
20