Toa WT-D5800 Mode D'emploi page 19

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8.3.8. eQ setting
This setting permits adjustment of the WT-D5800 unit's audio output for a more easily heard sound
quality. (Default setting: OFF)
step 1. In setting mode, select the setting item "EQ PRESET" with the Up or Down key.
step 2. Press the Set key, and the LCD screen displays the current setting.
step 3. Select the desired EQ setting with the Up or Down key.
The display cycles through the contents with each depression of the Up or Down key.
Note
When leaving the original EQ setting unchanged, select "EXIT" with Up or Down key and
press the Set key. Then, the display returns to the "EQ PRESET" indication.
Tip
EQ setting selections are shown for each microphone model number.
step 4. Press the Set key to register the setting.
This terminates the EQ setting, and the display returns to the "EQ PRESET" indication.
step 5. When any other setting is not needed, select "EXIT" with the Up or Down key and press the
Set key.
The unit returns to the normal operating state.
Note
When another setting is needed, select the necessary setting item with the Up or Down key
and press the Set key.
8.3.9. contact out setting
Make contacts can be provided from the WT-D5800 unit depending on the microphone status.
See p. 10 for details regarding each setting.
step 1. In setting mode, select the setting item "CONTACT OUT" with the Up or Down key.
step 2. Perform ENABLE/DISABLE setting.
2-1. Press the Set key, and the LCD screen displays the "ENABLE/DISABLE" indication.
Note
When leaving the original CONTACT OUT setting unchanged, select "EXIT" with Up
or Down key and press the Set key. Then, the display returns to the "CONTACT OUT"
indication.
2-2. Press the Set key, and the LCD screen displays the current setting.
2-3. Select "ON" or "OFF" with the Up or Down key.
2-4. Press the Set key to resister the setting.
This terminates the ENABLE/DISABLE setting, and the display returns to the "ENABLE/
DISABLE" indication.
Note
When leaving the original ENABLE setting unchanged, select "EXIT" with Up or Down key
and press the Set key. Then, the display returns to the "ENABLE/DISABLE" indication.
19

Publicité

Table des Matières
loading

Table des Matières