Toa WT-D5800 Mode D'emploi page 17

8.3.5. code setting
Perform code setting by selecting a code from among 10 different numbers. Only the audio of the
microphone assigned with the same code as the WT-D5800 unit can be output.
Notes
• Complete the bank and channel settings for the WT-D5800 unit and the microphone before
performing the code setting.
• Enabling the Encryption Function after completion of the code setting will invalidate the code
setting.
step 1. In setting mode, select the setting item "CODE" with the Up or Down key.
Note
The "CODE" indication is not displayed while the Encryption Function is enabled, making
it impossible to set the code.
step 2. Press the Set key, and the LCD screen displays the current setting.
step 3. Select the desired code number with the Up or Down key.
The display cycles through the contents with each depression of the Up or Down key.
Note
When leaving the original code number unchanged, select "EXIT" with Up or Down key and
press the Set key. Then, the display returns to the "CODE" indication.
step 4. Press the Set key to register the setting.
This terminates the code setting, and the display returns to the "CODE" indication.
step 5. When any other setting is not needed, select "EXIT" with the Up or Down key and press the
Set key.
The unit returns to the normal operating state.
Note
When another setting is needed, select the necessary setting item with the Up or Down key
and press the Set key.
17