Installation; Preparation - Dovre BOW Installation Et Mode D'emploi

Installation

Preparation

Please check the appliance for damage caused dur-
ing transport or any damage or defects immediately
after delivery.
If you detect transport damage or any other
damage or defects, do not use the appliance
and notify the supplier.
Remove the removable parts (fire-resistant inner
plates, fire compartment, fire basket, ash removal
port and ash pan) from the appliance before you
start installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of the removable parts, so
that you can re-position the parts in the correct
place later on.
1. Open the door; see the following figure:
2. Remove the fire-resistant inner plates; see the fol-
lowing figure:
a. Remove the inner plates on the back, first (5)
then (4).
b. Remove the inner plates left (3) and right (6).
c. Remove the baffle plate (1) by lifting one part,
and remove part two by lifting over the hook at
the front.
d. Remove the fire basket (7).
Subject to change because of technical improvements
09-20021-182
e. Remove the stove base (8).
f. Remove the ash pan (9).
Vermiculite inner plates are light and tend
to be ochrous in colour on delivery. They
insulate the combustion chamber to boost
combustion.
1
4
3
7
8
9
Removable internal parts
1 baffle plate
3 inner plate left
4 left-hand rear inner plate
5 right-hand rear inner plate
6 inner plate right
7 fire basket
8 stove base
9 ash pan
1
5
6
8
09-20021-190
1
3
4
09-20021-186
9