Recall Function; "Keep Warm" Function; Bridge Or Automatic Bridge Function - Pando E-390 Manuel D'installation

Recall Function

After switching off the hob (
• cooking stages of all cooking zones (Booster)
• minutes and seconds of programmed cooking zone-related timers
• Keep warm function
• Automatic cooking
The recall procedure is following:
• Press the key [
• Then press [ II ] before the light stops blinking.
The previous settings are again active.

"Keep warm" Function

This function allows the reach and automatically maintains at the temperature of 70°C.
This will avoid liquids overflowing and fast burning at the bottom of the pan.
• To engage, to start the function « Keep warm »:
Action
Activate the Keep warm
To stop
The maximum duration of keeping warm is 2 hours.

Bridge or Automatic Bridge Function

This function allows the use of 2 cooking zones at the same time with the same features as a
single cooking zone. With this function the Booster function is allowed on the left and center
zones.
Action
Activate the hob
Activate the bridge
Increase bridge
Stop the bridge
), it is possible to recall the last settings.
] for 2 sec.
Control panel
Press on key [
Press on key [
Control panel
Press key [ ] for 2 sec.
Place a pan on one of the two zones
that will be bridged and press
simultaneously the corresponding
selection keys
or
Automatically: put a great pan on the
2 zones and press on the 2 "SLIDER"
Slide on the "SLIDER"
witch indicates the power
Press simultaneously
of the 2 cooking zones
40
]
]
Display
[ ]
U
[ 0 ]
Display
[ 0 ]
[ 0 ] and [ ]
[ ] blink
[ ]
[ 1 ] to [ 9 ]
[ 0 ]
EN