Residual Heat Indication; Booster And Double Booster Function; Timer - Pando E-390 Manuel D'installation

Residual heat indication

After the switch off of a heating zone or the complete stop of the hob, the heating zones are still
hot and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
As far as the residual heat indicators are on light, don't touch the heating zones and don't put any
heat sensitive object on them. There are risks of burn and fire.

Booster and double booster function

Booster [ P ] and Double Booster [
If this function is activated the heating zones work during 10 minutes with an ultra high Power.
This is foreseen for example to heat up rapidly big quantities of water, like nuddles
• Start up / Stop the booster:
Action
Start up the booster
Stop the booster
• Start up / Stop double booster
Action
Start up the booster
Start up double booster
Stop the double booster
Stop booster
• Power management:
The total cooking hob is equipped with an overall maximum of Booster power. When the Booster
function is activated, the electronic system automatically regulates all "Boosters" selected to
equalise the available power to each element selected for booster. The display is blinking on [ 9 ] for
a few seconds and then shows the maximum of Booster allowed :
Heating zone selected
[ P ] is displayed

Timer

The timer is able to be used simultaneous with all heating zones and this with different time
settings (from 0 to 1H59 minutes) for each heating zone.
• Setting and modification of the cooking time:
Action
Select a zone
Select the power level
Select theTimer
Decrease the time
Increase the time
After a few seconds, the [
The time is confirmed and the timer starts.
] grant a boost of Power to the selected heating zone.
Control panel
Slide to the end of the "SLIDER"
Or press directly on the end of
the "SLIDER"
Slide on the "SLIDER"
Control panel
Slide to the end of the "SLIDER"
Or press directly on the end of
the "SLIDER"
Re-press on the end of the "SLIDER"
Slide on the "SLIDER"
Slide on the "SLIDER"
The other heating zone: (example: power level 9)
[ 9 ] goes to [ 8 ] and blinks
Control panel
Press a zone
slide on the "SLIDER"
Press key [ ]
Press key [ - ] from the timer
Press key [ + ] from the timer
] display stops with blinking.
38
Display
[ P ]
[ 9 ] to [ 0 ]
Display
[ P ]
[ and P ]
[ P ] to [ 0 ]
[ 9 ] to [ 0 ]
Display
[ 0 ]
[ 1 ] to [ P ]
Timer display on
[ 60 ] to 59, 58...
Time increase
EN