Cooking Plate Cleaning And Maintenance; Hood Maintenance And Cleaning - Pando E-390 Manuel D'installation

COOKING PLATE MAINTENANCE AND CLEANING
Switch-off the appliance before cleaning.
Do not clean the hob if the glass is too hot because they are risk of burn.
• Remove light marks with a damp cloth with washing up liquid diluted in a little water. Then
rinse with cold water and dry the surface thoroughly.
• Highly corrosive or abrasive detergents and cleaning equipment likely to cause scratches
must be absolutely avoided.
• Do not ever use any steam-cleaner or pressure washer.
• Do not use any object that may scratch the ceramic glass.
• Ensure that the pan is dry and clean. Ensure that there are no grains of dust on your
ceramic hob or on the pan. Sliding rough saucepans will scratch the surface.
• Spillages of sugar, jam, jelly, etc. must be removed immediately. You will thus prevent the
surface being damaged.
• Do not use a steam cleaner to clean this appliance.
• Ensure the cooking pan bases are clean and in good condition prior to using them to
prevent any damage to the surface of the device.
HOOD CLEANING AND MAINTENANCE
Regular cleaning of the hood guarantees correct and error-free operation and extends the life of the
hood. Be sure to clean the grease filters according to the manufacturer's recommendations.
Filter cleaning indicator
When the hood is on and the suction power is set to [0], the time remaining before cleaning the filter
is displayed on the timer display.
The default setting is 30 hours, but you can change this setting if you want.
• Show the remaining time:
Action
Activate the hood
• Grease filter cleaning indicator:
When the grease filters are to be cleaned, the timer display shows [00h] and a dot flashes on the
hood selection key.
• Reset the time remaining before cleaning the hood filter
Action
Activate the hob
Select the hood
Reset the counter
Confirm the setting
Control panel
press on the hood selection key
Control panel
press key [ ] for 2 sec
press on the hood selection key
press on the timer key for 3 secondes
press on the timer key again
43
EN
Display
[remaining time] on the
timer display
Display
[ 0 ] and a dot flashes on
the hood selection key
[ 0 ] and [ 00h ] on the
timer display
The last user-specified
setting is activated
-