Handling The Remote Controller; Replacing Batteries - Oceanic OCEACLIM120W0 Manuel De L'utilisateur

Handling the remote controller

8m
CAUTIONS
The air conditioner will not operate if curtains, doors or other materials
block the signals from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose
the remote controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct
sunlight, the air conditioner may not function properly. Use curtains to
prevent the sunlight from falling on the receiver.
If other electrical appliances react to the remote controller. either move
these appliances or consult your local dealer.

Replacing batteries

NOTICE:
Batteries are not supplied
Location of the remote controller.
Use the remote controller within a distance of 8
meters (26.25ft) from the appliance, pointing it
towards the receiver.
The remote controller is powed by two dry
batteries(R03/LR03X2) housed in the rear
part and protected by a cover.
(1) Remove the cover by pressing and sliding off.
(2) Remove the old batteries and insert the new
batteries,placing the(+) and (-) ends correctly.
(3) Reattach the cover by sliding it back into
position.
.
NOTE:
remote controller erases all programming.
After inserting new batteries, the remote
controller must be reprogrammed.
When the batteries are removed, the
109