Mig/Mag - Syn On Welding - Helvi 77611978 Mode D'emploi

10.0
With the torch connected, the wire installed and the gas connection made, earth cable to the Negative
output terminal on the front of the unit.
Mode Key -
Press the Mode Key till the MIG/MAG Welding
Screen is viewed on the display.
MIG/MAG Function Setup Key -
Press the Setup Key - 3.1 - in MIG/MAG Mode to
access the parameters' setup screen .
Use the Right Regulation Knob
"Synergy ON" Mode for normal welding.
Use the Mode Key - 1 - to go back to the MIG/
MAG main screen. Refer to paragraph 7 for the
other parameters' setting.
Right Regulation Knob -
Use the Right Regulation Knob to select the
thickness of the material to be welded.
Note: thickness is refered to a fillet welding
Material Key -
Use the Material Key to view the Synergic Welding Curves available on the unit.
Turn the Right Regulation Key - 5 - or press the Material Key - 6.1.2 - to choose the desired Synergic
Curve, suitable to the type of wire and to the gas going to be used for welding; to confirm your choice
simply press the Mode Key - 1 - to go back to the main screen.
Material
GAS
Once a Synergic Curve is selected, Slope, BBT, Inductance, Wire Speed Balance and Material thickness
settings go back to their default values.
Left Regulation Knob -
11.0 TIG AND MIG/MAG SETUPS SAVE & RECALL
Prog Save & Recall Key -
Figure 17

MIG/MAG - SYN ON WELDING

-
1
- - to select the
5
-
5
-
6.1.2
-
7.3
Use the Left Regulation Key to balance the wire speed in % (±40%) and increase or
decrease the arc lenght.
-
4
Use the Prog Save & Recall Key to save and recall the parameters
set by the operator (refer to paragraphs 6.0, 6.2, 9.0 and 10.0).
To save the setup proceed as follows:
• Press the PROG Key - 4 -
• Turn the Right Regulation knob - 5 - to choose the program
• To save the program keep the PROG Key pressed, a beep and
To recall a saved program proceed as follows:
• Press the PROG Key - 4 -
• Turn the Right Regulation knob - 5 - to choose the desired
• Press the PROG Key - 4 -, the wording "LOADING" will confirm
1
-
3.1
7.3
number to save in.
a the wording "OK" will confirm the save.
program number.
the program loading.Use the Mode Key - 1 - to go back to the
MIG/MAG main screen.
35
2
6.1.2
Figure 15
Welding Wire Thickness
Figure 16
Program number
3.1
5