Control Interface - Helvi 77611978 Mode D'emploi

4.0
1
7
1 Mode Key
• welding process selection
• return to the main screen after parameters setting
2
Graphic Display
3 Setup Key
setting of the secondary parameters in all welding processes
3.1Mig/Mag Function
Synergy: OFF /ON, 2Stroke/4Stroke/Spot welding, Spot Time, Motor Slope, BBT, Electronic Inductance, Post
Gas, Crater Filler
4 Prog save & recall Key
saves and recalls the functioning points that may be changed by the operator
5 Right Regulation Knob ( Volts / Amps)
Main Regulation Knob
6
Material Key
submenus selection key
6.1 MIG/MAG
6.1.1 Manual Mig/Mag (synergy OFF)
Adjustment of the electronic inductance value
6.1.2 Synergic Mig/Mag
Screen access for the synergic program selection
7 Left Regulation Knob
7.1 MMA
• HOT START
MODE Key works as BACK key in all menus.
SETUP Key allows to run through the menus by selecting in sequence the modifiable parameters.
The right knob changes the value previously selected with the SETUP Key.

CONTROL INTERFACE

2
6
7.2 TIG
• Slope Down ( Tig )
27
3
4
5
7.3 MIG/MAG
• Wire speed ( Mig )
• Balance (Synergic Mig)
Figure 1