Maintenance, Care And Cleaning; Battery Replacement; Troubleshooting - SPORTSTECH STX300 Mode D'emploi

8. MAINTENANCE, CARE AND CLEANING

NOTE: Please do not use aggressive or corrosive cleaning agents or solvents to clean our stepper. Also no detergents
please. Also, make sure that moisture does not penetrate the computer.
1. Please ensure that our stepper is cleaned with a soft damp cloth at least once a week.
2. Should you notice squeaking noises, lubricate our stepper or the moving parts and axial connections.
3. Before using our device, please check before each exercise whether there is any damage or wear. Please check
especially the plastic washers in the axles of the linkage, the tread areas and pull straps or strap fixtures to ensure
proper function. If parts are defective or need to be changed, you must stop using our device.
4. Caution: Plastic parts and pull straps wear out over time. Pay attention to them.
If you notice that information in the display is fading, the battery must be replaced.Please use a LR44 battery.
1. Carefully unplug the computer from its fixing please and turn it over.
2. Carefully remove the battery now.
3. Replace battery by a new one. Note the different poles.
4. Reinstall the computer into our stepper.
PROBLEM
No display
Strong noise during use

9. BATTERY REPLACEMENT

10. TROUBLESHOOTING

POTENTIAL CAUSES
Battery is empty or missing
Connection cable is pinched or
damaged
Loose plug connection
Elektronics is damaged
Loose screws
Lack of lubrication
33
SOLUTIONS
Replace battery
Replace connection cable
Connect plugs correctly
Replace training computer
Tighten screws
Lubricate all moving parts