Maintenance And Care - SPORTSTECH FPR300 Manuel

1. The safety of the device can only be maintained if it is regularly checked for wear and / or wear, e.g.
at the connection points.
2. Check all parts before using the device and tighten them if necessary, replace any defective parts
immediately and do not use the device until it is in perfect condition again.
3. Do not try to repair this device yourself. If you have difficulties installing, operating or using your
training device, or if you suspect that parts may be missing, please contact your dealer.
4. Check all screw connections regularly. Check locking pins, socket pins, snap hooks, rope eyes etc.
for functionality and wear.
5. Clean the device at regular intervals. Sweat is corrosive and may cause rust to form.
6. The hardened steel shafts of the linear systems are not necessarily rustproof. Lubricate or spray
them weekly with a clear, smooth grease (specialist dealer or with WD40 oil), thinly from top to
bottom. IMPORTANT: Remove old grease / oil and dirt beforehand.
7. The steel cables must be checked carefully and every day. In particular, the connection areas at the
ends of the ropes must be checked for tightness and breakage. The screw terminals on the rope
ends must be checked regularly, but especially before the power rack is put into operation, and
tightened if necessary (the procedure for this is described in the illustrated assembly instructions).
8. If the steel rope is damaged, the training must be stopped immediately and the rope replaced im-
mediately. IMPORTANT: Failure to comply may result in injury!
9. The device can best be cleaned with a cloth dampened with water. Do not use solvents.

MAINTENANCE AND CARE

39
EN