Hazardous Location Considerations; Explosion Hazard - Rockwell Automation MicroLogix 1400 Notice D'installation

Hazardous Location Considerations

This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D or
non-hazardous locations only. The following WARNING statement applies to use in
hazardous locations.

EXPLOSION HAZARD

WARNING
Use only the following communication cables in Class I, Division 2 hazardous
locations.
Environment Classification
Class I, Division 2 Hazardous Environment
• Substitution of components may impair suitability for Class I, Division 2.
• Do not replace components or disconnect equipment unless power has been
switched off.
• Do not connect or disconnect components unless power has been switched off.
• This product must be installed in an enclosure. All cables connected to the product
must remain in the enclosure or be protected by conduit or other means.
• All wiring must comply with N.E.C. article 501-10(b) and/or in accordance with
Section 18-1J2 of the Canadian Electrical Code, and in accordance with the authority
having jurisdiction.
Automates programmables MicroLogix 1400
Communication Cables
1761-CBL-AC00 Series C or later
1761-CBL-AM00 Series C or later
1761-CBL-AP00 Series C or later
1761-CBL-PM02 Series C or later
1761-CBL-HM02 Series C or later
2707-NC9 Series C or later
1763-NC01 Series A or later
1747-CP3 Series
Publication 1766-IN001C-FR-P – Octobre 2009
11