Removing And Replacing The Extraction Tower And Emptying The Reservoir; Cleaning The Grease Filters And The Ventilation Tower Glass - Novy 40 00 up Série Mode D'emploi

Discolouration of the hob does not have any influence on the
operation or strength of the vitro-ceramic. It is not a form of
damage to the hob, but it is a result of residues that have not
been removed and have therefore burnt-in.
Shiny spots occur as a result of wear caused by the base of the
pans, in particular when using cooking pans with an aluminium
bottom or when using the wrong cleaning agents. These can
only be removed with great difficulty using common cleaning
agents. If necessary, repeat the cleaning several times.
Due to the use of aggressive cleaning agents and scratching
caused by the pan bases, the glass surface is rubbed off over
the course of time, leaving dark stains.
Do not use the cooking plate as a table top or
for putting utensils on.
Always lift up the pans/pots and do not slide them along the
glass plate.
9.2 Removing and replacing the extraction
tower and emptying the reservoir
If liquid has entered the intake opening, it will be
– Collected in the fixed watertank (capacity of 150ml).
– Remove the extraction tower from the lift system.
– Clean/remove the contents in the fixed watertank
– Replace the extraction tower in the lift system.
9.3 Cleaning the grease filters and the
ventilation tower glass
After 20 hours of cooking, the 4 LEDs on the hood touch control
will start to blink.
The grease filter is located in the extraction tower, the entire
tower can be cleaned in the dishwasher together with the
grease filter.
The grease filter can also be removed separately from the
extraction tower for cleaning, follow the steps below.
OF
The filter can be cleaned as follows:
– In the dishwasher

By hand: Immerse the filter in a mixture of boiling water and
grease-cutting dishwashing liquid. Use warm water to rinse the
filter under the tap, then leave it to dry.
– Clean the extraction tower with a damp cloth with, if
necessary, a pH-neutral detergent

After cleaning:
– Replace the filter in the extraction tower
– Replace the tilting cover in the extraction tower.
– Replace the extraction tower in the lift system.
– Press the control key
– 62 –
1 2
INFO: Clean the grease filters using a standard
dishwashing programme at low temperature.
WARNING: If the instructions described above are
not followed, residue in the filter may cause a fire.
for 3 seconds.
3