Manual Bridge Function; Locking The Controller; Controlling The Extraction Tower; Extractor Hood Control Panel - Novy 40 00 up Série Mode D'emploi

Turn off automatically at the end of the cooking time:
As soon as the selected cooking time is up, the display will flash
00
, an audible sign will be heard, and the cooking zone will
turn off. To stop the audible signal and the flashing light, press
[—] or [+] on the timer.

5.1.7 Manual Bridge function

This function allows you to link the 2 left and 2 right zones
so they operate as 2 large zones. This function can only be
activated manually when a large pot/pan is placed on the
cooking surface.
Bridge function
Manual activation
Simultaneously press on both cooking zone
selection buttons +
be linked.
Increase the power
Press the [+] or [—] button
Switch bridge function off
Simultaneously press on both cooking zone
+
selection buttons
zones.

5.1.8 Locking the controller

To avoid a hob selection being changed, during cleaning for
example, the controller must be locked (except the on/off
button).
Locking
Lock
1. Switch on the hob using the
2. Press the [—] and of the back zone
simultaneously.
3. Press the button of the back zone
again.
Unlock:
1. Switch on the hob using the
2. Press the [—] and of the back zone
simultaneously.
3. Press the [—] button again.
Display
of both zones to
0
0‐9
0
of both linked
Display
button.
L
button.
0
6 CONTROLLING THE EXTRACTION
TOWER

6.1 Extractor hood control panel

Switch on/lift
Decrease extraction speed
Extraction speed indication
Increase extraction speed
Cleaning indication for recirculation filter (optional)

6.2 User modes

This device can be used in the exhaust or recirculation mode
(standard setting upon delivery)

6.2.1 Exhaust mode

The air sucked in is first cleaned by the grease filters before
being removed to the outside. This can be achieved by making
use of a series of channels connected between the device and
a wall exhaust cover.
To set the device in exhaust mode, press and hold the key
combination [+] and [—] for 3 seconds when the extraction
tower is closed.
The 3 green LED indication for recirculation filter will blink 5x.
rd

6.2.2 Recirculation mode

The air sucked in is first cleaned by the grease filters. The scents
are then removed in the recirculation filter before re-entering the
kitchen.
To set the device in recirculation mode (default setting), press
and hold the key combination [+] and [—] for 3 seconds when
the extraction tower is closed. The red LED will blink 5x.
– 58 –
Extraction control