Storch ProCut mineral PLUS Mode D'emploi page 48

Cutting depth setting ProCut mineral PLUS 128
The ProCut mineral PLUS 128 offers the ability to engage the blade guide in 3 different positions, thus setting different
cutting depths. Users can change between the 3 different positions without tools by pulling the marked locking bolt to
release it, and moving the blade guide to the desired position. Then release the locking bolt and allow it to engage at the
defined latching point. See the following illustrations.
Latching position no. 1
Cutting depth 6 - 14 cm
Top
Latching position no. 2
Cutting depth 14 - 22 cm
Top
Latching position no. 3
Cutting depth 22 - 30 cm
Top
Translation of the original instruction
Bottom
Bottom
Bottom
48