Kostenlose Service-Hotline: 08 00. 7 86; Gratis Service-Hotline: 08 00. 7 86; Ligne D'assistance Sav Gratuite: +49 800 7 86; Free Service Hotline: 0800 786 - Storch ProCut mineral PLUS Mode D'emploi

Assembling the cordless reciprocating with in-
sulating material blade on the guide carriage
Now thread the blade, which is assembled on the saw,
through the guide carriage and the front and rear blade gui-
des. Then press the saw stop release button on the cord-
less reciprocating saw again (see assembly of the insula-
ting material blade on the cordless reciprocating saw) and
push the cordless reciprocating saw up to the end of the
saw stop on the guide carriage.
After unlocking the guide carriage at the blade guide lo-
cking mechanism, the guide carriage can be easily routed
down along the blade guide.
Caution:
Before unlocking the guide carriage, secure the cordless re-
ciprocating saw against dropping out with your other hand.
We recommend wearing suitable protective gloves during
all work on or with the ProCut mineral PLUS / ProCut mi-
neral PLUS 128!
The device is now ready for use.
Selecting the ProCut mineral cutting components PLUS / ProCut mineral PLUS 128
We recommend the following combinations for the most common insulating materials (these depend on the thickness of
the board and the material itself):
Insulating material
Mineral wool
Glass wool
Perimeter rigid foam XPS
Resol
Hybrid
Cordless reciprocating saw, art. no. 57 01 95
Insulating material blade for cordless reciprocating saw, art. no. 57 01 96
Insulation knife, 48 cm, art. no. 43 62 49
Mineral handsaw, 48 cm, art. no. 43 01 55
The following applies as a general rule: dense and hard insulating material tends to require the use of a saw.
Note:
The use of the cordless reciprocating saw hugely facilitates cutting various insulating materials. If the cordless recipro-
cating saw is not available, or if the batteries are not sufficiently charged, you can also cut the insulating boards with an
insulating material knife or a mineral hand saw.
All
Cordless reciprocating saw
Cordless reciprocating saw
Cordless reciprocating saw
Cordless reciprocating saw
Cordless reciprocating saw
47
Press
Board thickness
up to 100 mm
Knife / saw
Knife
Saw
Saw
Saw
Translation of the original instruction
100 mm and above
Saw
Knife
Saw
Saw
Saw