Hendi 238486 Mode D'emploi page 9

Parts
All accessories such as
cooking racks, handle,
drip tray, etc.
External surfaces
Interior surfaces
Troubleshooting
If the appliance does not function properly, please check the below table for the solution. If you are still unable
to solve the problem, please contact the supplier/service provider.
Problems
The appliance does not switch ON.
The main switch (5) does not light up
in red.
The appliance does not heat up. But
main switch (5) lights up in red and
power level knob (1) is set.
Appliance does not reach the set
temperature after long operation
time and power level knob (1) is set.
In case of any doubt, always contact your supplier!
Technical specification
Item no. : 238486
Operating voltage & frequency : 230V~ 50Hz
Rated wattage : 1600W
Protection class : Class I
Remark: Technical specification is subjected to change without prior notification
How to clean
- Soak in warm, soapy water or about 10 to 20 min-
utes.
- Rinse under running water thoroughly.
- Wipe with a soft clean cloth and a little neutral
detergent. Make sure no water or moisture enter
inside the appliance.
- Remove any food residues or wood chips residues
- Wipe with a soft clean cloth and a little neutral
detergent. Make sure no water or moisture enter
inside the appliance.
Possible causes
Power plug is not connected
properly with the electrical pow-
er outlet.
The main switch (5) is not
pressed.
Main switch (5) is defective.
Power level knob (1) is defective.
Heating element (4) is defective
Power level knob (1) is defective.
Possible solutions
Make sure the power plug is
connected properly with the
electrical power outlet.
Press the main switch (5) to
the "ON" position.
Contact the supplier.
Contact the supplier.
Contact the supplier.
Contact the supplier.
Waterproof protection class : IPX4
Actual temperature range : approx. 50°C ~ 160°C
(Depending the outside temperature)
Dimension : Approx. 540 x 380 (H) 720 mm
Remark
Dry all parts well at
last.
9
EN