Miles Industries STONEFIRE SFFK01 Manuel D'installation page 5

1. Unpack the kit and ensure you have all the components as shown on page 1.
2. Fix the back support bracket to the
530 engine with 2 #8 Phillips screws
supplied.
3. Place the bottom panel under the front
of the 530 engine. It is not necessary
to attach it to the firebox. However, if it
is desired, the panel can be fixed to the
engine by drilling two holes in the panel
and fixing it with 2 #10 Phillips screws
supplied.
The fireplace should now be leveled at
1-1/2" above the ground. If the fireplace
needs to be higher to accommodate floor
finish, ensure that the whole surface
underneath the fireplace AND the bottom
panel is raised evenly.
4. Fix the heat duct, the side brackets and the top bracket to the firebox with #10
Phillips screws provided. See the assembly diagram on the previous page.
Note: When using the SFFT01 4-Sided Trim (supplied separately), the protruding
extension baffle must be removed from the top bracket assembly. Remove the
baffle by inserting a Phillips screwdriver through the space between the top
bracket and the baffle and remove the 2 screws. Install the top bracket (with the
extension baffle removed) as indicated on page 4.
5. Required for installation in combustible construction. Fix the standoffs to the
back of the fireplace with 8 #10 Phillips screws supplied.
6. Required for installation in combustible construction. Add the insulation pad on
top of the engine, cutting around the pipe if installing a top vent.
RH Side View
Remove
extension
baffle
1-1/2"
5