ITW Food Equipment Group VC4GD Mode D'installation Et Mode D'emploi page 6

Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901
Assembling the Legs to the Oven
BACK
The legs must be installed on the bottom of the oven. Gently position the
oven on its side, taking care not to scratch or damage it.
Attach each of the four leg assemblies to the bottom of the oven with
the 24 bolts and lockwashers (six per leg). Carefully raise the oven to its
normal position.
ASSEMBLING THE STAND TO THE OVEN
FRONT
Attach each of the four leg assemblies to the bottom of the oven with
the 24 bolts and lockwashers (six per leg). Carefully raise the oven to its
normal position.
RACK SUPPORT
Attach the undershelf to the legs with eight bolts and lockwashers (two per
leg).
RACK GUIDE
Install the rack guides into the undershelf at desired locations (for pan or
flat rack), then attach the rack supports to the top end of the rack guides.
PL-56178
Attach rack supports to the leg assembly by removing one middle bolt
Fig. 2
and reattaching back through the end holes in the rack support (Fig. 2).
ASSEMBLING STACKED OVENS
STACKING FLUE
Unpack the ovens and stack kit. Position the oven to be used as
the bottom oven on its back for access to the oven bottom, taking
care not to scratch or damage it. The gas pipe protrudes beyond
the back; provide for this when the oven is tipped back by resting
it on suitable spacers (2 x 4" [51 x 102 mm], etc.). Attach the four
leg assemblies with the 24 bolts and lockwashers (six per leg).
Place the lower oven (with legs) on the floor and remove two /
7
16
inch (11 mm) diameter knockouts on each side of the top cover.
Remove vent guard and discard it.
Move the oven with legs to the installed position and place upper
oven on top of lower oven using the locating studs.
Install the stacking flue (Fig. 3) with the four screws provided.
Connect the piping between the top oven and bottom oven. For
PL-53564
all gas supply connections, pipe joint compound must be resistant
to the action of propane gases.
Fig. 3
LEVELING
Make sure that the oven racks are level in the final installed position. If the oven is installed on legs,
turn the adjustable feet in or out to level the oven front-to-back and side-to-side. If the oven is installed
on casters, loosen set screws and turn casters in or out to level the oven front-to-back and side-to-side.
Retighten set screws after leveling.
– 6 –