Stanley STHT77366 Manuel D'utilisation page 8

EN
User Manual
app contains a detailed instruction tutorial on this
procedure under SETTINGS: Align Laser.
1. In the Smart Measure Pro app, tap on
SETTINGS, then tap Align Laser.
2. Rest your device on top of a flat, hard surface,
such as a table top. Then hold your device
vertically and aim it towards two objects that
are at different distances, for example the edge
of a doorway. Ensure that the closest object
has a vertical edge.
• The distance between the two objects
should be at least 15 feet (5 meters).
• You can use the vertical edge of an open
door and the wall of the room behind it.
3. Slowly turn your device to pass the crosshair
across the vertical edge
distance measurement
crosshair in the center of the screen moves on
and off the vertical edge.
4. If the measurement changes at the point where
the crosshair moves on and off the vertical
edge, your laser is correctly aligned. If this
does not happen at the correct point, tap on
the left and right black arrows
the correct point.
5. Turn your device horizontally and aiming at
the same two objects, repeat steps 3 and 4 to
align the laser horizontally.
To save the alignment, tap Done.
Note: While on the SETTINGS screen, you can
select your preferred units of measure.
Return to the main menu by tapping the Back
button.
8
and check that the
1
changes when the
2
to adjust to
3
Measuring With Your Smart Measure Pro
Measurements taken with your Smart Measure
Pro should be used for estimating purposes.
Because these measurements are reliant on user
input, it is recommended you become familiar
with the measurement process and practice
the technique prior to using the measurements
obtained with your device.
To measure accurately with your Smart Measure
Pro, you need to ensure that:
1.Your target is a flat surface and you intend to
measure on that plane.
2.Your target is or has a rectangular shape on it
(to assist with image alignment).
3.Your laser (indicated by the cross-hair on the
screen) is pointed at your target. The crosshair
should be on a solid surface and not a window
or other reflective surface.
4.You are as square to the target as possible.
Please reference the following target distance
and positioning guide when taking a Smart
Measure Pro photo.