Stanley STHT77366 Manuel D'utilisation page 4

EN
User Manual
performance can be obtained if the battery pack
is charged when the air temperature is between
65 °F –75 °F (18° and 24 °C).
Never use any charger or cable that is damaged,
as it may present a risk of fire, explosion, leakage,
or other hazard.
FCC Information
Smart Measure Pro
Model: STHT77366
Bluetooth Information
FCC ID: 2ACBG3000
IC ID: 11952A-3000
FCC Compliance
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation
FCC Statement
WARNING: Changes or modification to this
unit not expressly approved by party responsible
for compliance could void the user's authority to
operate the equipment. Note: This equipment has
been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of
the FCC rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
4
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment
and the receiver
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected
• Consult the dealer or an experienced radio/TV
technician for help
Canada, Industry Canada (IC) Notices
Class B digital circuitry of this device complies
with Canadian ICES-003. This device complies
with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following
two conditions:
• This device may not cause interference.
• This device must accept any interference,
including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes:
• l'appareil ne doit pas produire de brouillage;
• l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.
Under Industry Canada regulations, the radio
transmitter(s) in this device may only operate
using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by