Exiting; Resetting The Extender Or Changing The Computer - HP MediaSmart Connect x280n Guide D'installation Et Manuel De L'utilisateur

Press a Channel button (Ch+ or Ch--) to change the channel
when watching live TV.
Press Recorded TV to display the Windows Media Center
Recorded TV menu. Use the menu to watch pre-recorded TV
programs.
Press Guide to display the Windows Media Center Program
Guide. Use the guide to browse through program listings and
mark them for recording (press Record).
Press Record to begin recording the live TV program you are
watching, or to mark for recording the program listed in the
Windows Media Center Program Guide. This function is not
available in MediaSmart mode.

Exiting

To close the Windows Media Center window, do any of the
following by using the remote control buttons:
Press Media to display the Media menu.
Press Source and select a new input source.
On the Windows Media Center main menu, select Tasks,
and then click Exit.
Chapter 6: Using the Extender for Windows Media Center
Resetting the Extender or changing
the computer
Use these steps to reset the Extender for Windows Media Center
or to change the host computer. After the initial setup of the
HP MediaSmart Connect as an Extender, you must remove the
current setup information from the device before setting up a new
computer.
Your computer may require an active (live) connection to the
Internet while you set up the Extender.
1 Press Media on the MediaSmart remote control.
2 Select Settings, and then press OK.
n
Each time you set up the Extender or change the
computer, HP MediaSmart Connect generates a new
eight-digit key.
83