HP MediaSmart Connect x280n Guide D'installation Et Manuel De L'utilisateur page 49

5 Point the remote control at the device, and then press and
release the On/Off button on the remote control once. Wait
until the device indicator light stops blinking.
If the device turns off, continue with step 6.
If the device does not turn off, continue to press and
release the On/Off button, waiting each time for the
device indicator light to stop blinking, until the device
turns off.
n
Each time you press the On/Off button, the auto setup
tries a different code. Be sure to wait until the device
indicator light stops blinking before pressing the On/
Off button again. You may need to press the On/Off
button several times before the correct code is found.
Chapter 3: Using the Remote Control
6 Once the device turns off, press the OK button on the remote
control to save the code.
n
If you cannot find a code that controls your device, and
your device is not listed in the manufacturer codes, your
device cannot be programmed into this remote control.
This completes the steps to automatically program a primary
device. After programming a primary device, you can program a
second device for volume mapping; see "Programming a second
device for volume mapping" on page 47.
49