HP MediaSmart Connect x280n Guide D'installation Et Manuel De L'utilisateur page 46

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4
Press and hold down the Device button on the remote control
for 5 seconds, until the device indicator light blinks, and then
release the Device button. The device light blinks one more
time and then remains lit, indicating the remote control is in
programming mode.
IMPORTANT: Enter code 9, 9, 9, 9 to reset the selected
!
device to the factory default manufacturer value.
Enter code 8, 8, 8, 8 to enter auto setup mode; see
"Programming the device code by using auto setup
mode" on page 48.
Pressing the 1, 3, and 0 buttons on the remote control
at the same time resets all programmable devices to
factory values.
Chapter 3: Using the Remote Control
5
Enter the first four-digit code for your manufacturer from the
listing. If the code is accepted, the device indicator light
blinks twice. If the code is not accepted, the device indicator
light blinks three times.
n
If the device indicator light did not blink twice, repeat
step 4 and 5, entering either the same code or the next
code, if there is one.
6
Point the remote control at the device, and press the On/Off
button once. The device should turn off (or on if it is off).
If it does not, repeat steps 4 and 5, trying each code for your
brand until you find one that works. If it still does not work,
try searching for the code by using auto setup mode; see
"Programming the device code by using auto setup mode"
on page 48.
n
If the device does not have a On/Off button, press Play.
46

Publicité

Chapitres

Table des Matières
loading

Table des Matières