HP MediaSmart Connect x280n Guide D'installation Et Manuel De L'utilisateur page 45

Selected
device
(indicator) Remote control operates
HP MediaSmart Your HP MediaSmart Connect (only the
Connect second device for volume mapping can be
programmed for this mode).
TV Your TV. The default code is set to HP HDTV
(manufacturer code 1000), but you can
change this to any of the supported device
codes.
CBL Your cable or satellite set-top box. The default
code is set to Comcast cable set-top box
(manufacturer code 0040), but you can
change this to any of the supported device
codes.
DVD Your DVD player. The default code is set to
Sony DVD player (manufacturer code 0003),
but you can change this to any of the
supported device codes.
Chapter 3: Using the Remote Control
Selected
device
(indicator) Remote control operates (continued)
AUX There is no default code, but you can set this
to any of the supported device codes.
Programming steps
Follow these steps to program the remote control for the TV.
The steps are the same for the other device indicators. To find the
other device manufacturer codes, see the listing on the HP Web
site at: http://www.hp.com/support/mediasmart
1 Locate the brand of your device and the manufacturer codes.
See "Manufacturer TV codes" on page 106.
2 Turn on the TV, or the device you want to control.
3 Press the Device button on the remote control one or more
times to select the TV or device you want to program. Wait
until the device indicator light on the remote control goes out.
45