Filling The Engine Oil; Automatic Oil Shut-Off System; Filling The Petrol - Walter WWS-4TS Notice D'utilisation

Filling the engine oil

During commissioning or when changing the oil, first fill about 0.6 litres
of engine oil of one of the following types:
SAE 15W-30 | SAE 10W-30 | SAE 15W-40 | SAE 0W-30 | SAE 5W-40
• Remove the dipstick
counterclockwise.
• Wipe the dipstick using a clean cloth
and place it in a clean place.
• Check the engine oil level if
necessary (see chapter "Checking
the engine oil level").
• Insert a suitable funnel into the oil
B
filler neck
• Fill the engine oil until the hatched
surface of the dipstick is completely
wetted with engine oil. Check the
engine oil level again.

Automatic oil shut-off system

The drive unit comes with an automatic oil shut-off system. If there is not
enough engine oil, then the power generator cannot be started or it is shut off
automatically.

Filling the petrol

Turn the tank cap
clockwise and remove it.
Use a suitable funnel or filling tool for
filling.
Fill the tank with unleaded regular or
super petrol (ROZ 91 or 95). The petrol
filter in the tank filler neck should be
filled with petrol up to a maximum of half
its capacity.
Replace the tank cap on the tank filler
neck and turn it clockwise as far as it
goes.
K640061_Anleitung_DE_EN_FR_CZ_SI.indb 65 K640061_Anleitung_DE_EN_FR_CZ_SI.indb 65
A
by turning it
.
4
counter-
Using the power generator
A
B
4
08.02.2021 14:53:27 08.02.2021 14:53:27
65