Installation And Fixing; General Notes On Installation - Walter WWS-4TS Notice D'utilisation

Assembly
• Repeat the procedure for the other side of the handle.
• If you want to move the power generator, proceed in reverse sequence and
fold the handle forward until it locks into the provided retention clips.

Installation and fixing

• After the assembly, place the
generator carefully in a horizontal
position so that it stands on the
5
wheels .
• Turn the brake screw
clockwise direction through the
threaded housing.
• Tighten the brake screw by hand till
it reaches the inner housing of the
wheel.
• Ensure that the brake screw blocks
the wheel by moving the wheel
slightly.
• Repeat for procedure for all four wheels.
• If you want to transport or move the generator, then proceed in reverse
sequence.

General notes on installation

• Install the power generator only on level and firm ground.
• Install the power generator only in dry surroundings.
• Install the power generator in a place where people do not move about.
• Install the power generator in a place where it is not exposed to excessive
dust.
• Note the temperature and height limits as well as the safe minimum distances
(see chapter "Technical data").
• Keep all the accessories ready.
62
K640061_Anleitung_DE_EN_FR_CZ_SI.indb 62 K640061_Anleitung_DE_EN_FR_CZ_SI.indb 62
3
in a
3
08.02.2021 14:53:26 08.02.2021 14:53:26