EdilKamin FANTASY Installation page 40

on rm by pressing E
of pellets will be displayed
and can be changed using the
out of pellets, the stove will bloc and Stop Flame will appear
(see page ).
ote: Every now and again remember to reset the "pellet
reserve warning for it to function in a more reliable
manner. For any clari cation please contact the authorised
E LER who performed the rst st ignition.
This provides a reference indicator. Greater precision is
Edilkamin does not accept any responsibility for differences
from what is indicated (which may be due to external factors).
Environ ental te perature ad ust ent
this comfortable and simple adjustment feature, as standard in
this line of products, allows you to manage the stove power
based on the environmental temperature.
fter activating the " lima omfort function from the para-
meters menu (as the technical assistance centre -
can use this function to switch off the stove when it reaches the
set temperature. his function is combined with the
stove setting.
case remain unchanged.
fter the omfort lima function has been enabled by the
, you can activate deactivate it from the user menu. ress
the SE ey, loo for the " omfort lima menu with the
- eys, select it with the SE
buttons, save the desired setting and e it using the
Operation details Co fort Cli a ON
when set on , the stove modulates its power
by following the temperature set by the user. n reaching
environmental temperature, the stove switches off and then
switches on again independently when the temperature drops.
Te perature selection
n " omfort lima mode, by pressing the
synoptic panel or on the remote control, you can set the display
to the desired environmental temperature. So we will have the
following situations:
- t environmental temperatures below the setting, the stove
switches on independently, modulating the power automatical-
ly.
- ith environmental temperature reached (
switches to stand-by. he environmental temperature is sent
from the remote control; the remote control transmitter must
be visually aligned with the receiver of the synoptic panel.
f the remote control is incorrectly positioned, it cannot send
its recorded temperature. he stove therefore independently
switches to use of its on-board temperature sensor and conti-
nues thus until the connection with the remote is restored
Te perature ad ust ent with external ther ostat
another temperature control system is available as an alterna-
tive to the remote control. ou can in fact connect the thermo-
stat serial port to your home thermostat or any (clean output
contact) easily available one.
INSTRUCTIONS FOR USE
and the remaining quantity
that being loaded (default is
- eys). Should the hopper run
), we
L mode operation will in any
ey, set FF with the
button.
- buttons on the
) the stove
he stove will automatically recognise the connection with the
serial port of the thermostat under the following conditions:
ith environmental temperature lower than the thermostat
setting (contact closed), the stove modulates power normally to
follow the set temperature
- ith environmental temperature reached by the thermostat
(contact open), the stove switches to stand-by mode.
emperature
on guration provided by the
remote control
omfort
lima
parameter
"S R
parameter
onnection to
-
serial port no connection
-
- 40
-
emperature
provided by
o adjustment
e ternal
(factory setting)
environmental
thermostat
FF
es
with blue
no connection
serial cable