Product Overview - Hilti DSH 600-X Mode D'emploi

Masquer les pouces Voir aussi pour DSH 600-X:

Mode d'emploi (75 pages)

Mode d'emploi original (481 pages)

Mode d'emploi (36 pages)

Table Des Matières

Table des Matières

Les langues disponibles

▶ Always use an undamaged clamping flange of the correct diameter which fits the cut-off wheel used.

The correctly fitting clamping flange supports the cut-off wheel and thus reduces the possibility of wheel

breakage.

▶ Guide the product smoothly and do not apply lateral pressure to the cut-off wheel. Always bring the

cut-off wheel into contact with the workpiece at right angles. Don't attempt to alter the line of cut by

applying lateral pressure or by bending the cut-off wheel while cutting is in progress.

▶ Abrasive cut-off wheels which are used for wet cutting must be used up the same day as long periods of

exposure to moisture have a negative effect on the strength of the wheel.

▶ Never install a saw blade for cutting wood.

▶ Use only cut-off wheels that comply with the existing standards for cut-off wheels.

▶ Prior to installation and before use, check the cut-off wheel for damage. Do not install a damaged cut-off

wheel. Comply with the requirements stated by the manufacturer of the cut-off wheel.

2.8

CALIFORNIA PROPOSITION 65

Fuels used in gas or oil filled appliances and the product of combustion of such fuels contain chemicals

(including Benzene, toluene, xylenes, 1,3 butadiene and formaldehyde) known to the State of California to

cause cancer, birth defects or other reproductive harm. Wash hands after handling!

Description

3.1