Transferring Measurements; Error Messages/Trouble-Shooting - Sanitas SBM 50 Mode D'emploi

It is important to consult your doctor regularly for advice.
Your doctor will tell you your individual values for normal
blood pressure as well as the value above which your blood
pressure is classified as dangerous.
The WHO classification in the display shows the range of
the measured blood pressure.
If the values for systolic and diastolic pressure are in two
different WHO ranges (e.g. systolic in the grade hyperten-
sion range and diastolic pressure in the normal range), the
WHO classification on the unit always indicates the higher
range (grade hypertension in the example described).
7. saving, retrieving and deleting results
• The results of each successful measurement are stored
together with date and time. With more than 60 items of
measured data, the earliest items of data measured are lost.
• Move the touch screen activation switch to the ON position.
• Make a selection with the MEM button, and then confirm
the desired user memory with the START/STOP button.
If you press the MEM button again, the average value of
all the stored measured values in the user memory will be
displayed. If you press the MEM button again, the aver-
age value of the last 7 days for the morning measurement
will be displayed (Morning: 5 a.m. – 9 a.m., display
you press the MEM button again, the average value of the
last 7 days for the evening measurement will be displayed
(Evening: 6 p.m. – 8 p.m., display
. If
. If you continue to
26
press the MEM button, the most recent individual meas-
ured values with date and time are displayed in turn.
• You can delete the memory by pressing and holding the
MEM button for 3 seconds. All the values in the current
user memory are deleted after three beeps are output.
• To switch off the device, press the MEM button again or
the START/STOP button or push the touch screen acti-
vation switch to OFF.
• If you forget to switch off the device, it will switch off au-
tomatically after 2 minutes.

8. Transferring measurements

Connect the blood pressure monitor to your PC using the
USB cable. Activate the device by pressing the MEM but-
ton and use the START/STOPP button to select the desired
user memory. Start the data transfer using the PC software.
After two minutes of not being in use or if communica-
tion with the PC is interrupted, the blood pressure monitor
switches itself off automatically.

9. Error messages/trouble-shooting

In case of faults, the _ message appears in the display.
Error messages may appear if:
• systolic or diastolic pressure could not be measured (
or appears on the display)