SOMFY S&SO-RS100 io Notice page 27

For a roller shutter
with rigid links
and with stops =
Plug&Play Operation
No setting to be performed:
the end limits are set
automatically.
Check that the roller
shutter and its
accessories are
Please consult the roller
shutter manufacturer
or Somfy for information on
the compatibility of the drive
with the roller shutter and its
accessories.
few cycles.
be inverted (they adjust automatically without the need for any settings, after a
maximum of 2 complete cycles, from one end limit to the other). For a roller shutter
below 0.5 m² (0.6 mx 0.7 m), see Questions on the S&SO-RS100 io? section.
Copyright © 2014 - 2016 Somfy SAS. All rights reserved.
Step 1: Preprogramming the control point
For a roller shutter
without rigid links
and without stops
The upper and lower end
limits must be set in manual
mode.
Step 2
Setting / resetting
of end limits in
manual mode
Step 3: Programming the control point
OPERATION
For a roller shutter
without rigid links and
with stops or with rigid
links and without stops
The upper and lower end
limits must be set in semi-
automatic mode.
a
:
Setting / resetting
Non contractual images.
EN
b
Step 2 :
of end limits in
semi-automatic
mode
may
25