Location - Franklin Electric SubDrive75/2W MonoDrive Mode D'emploi

Mount the drive as close
as possible to the service
entrance panel.
Service Entrance
Panel
Use a dedicated branch circuit for the drive.
Wire directly from the service entrance panel.
(15A for SubDrive75/MonoDrive/SubDrive2W)
(20A for SubDrive100/MonoDriveXT)
(30A for SubDrive150)
(40A for SubDrive300)
Service entrance ground rod
6"
15 cm
GND
It is recommended to wire directly
to the service entrance panel.
(DO NOT wire to a sub panel
located in a home.)
Service Entrance
Panel
IN HOME
Sub Panel
GND
Mount drive to a sturdy
supporting structure (wall or post).
NEMA 1 - Indoor Only
NEMA 3R/NEMA 4 - Indoor/Outdoor
6"
15 cm
6"
15 cm
6"
15 cm
GND
GND

Location

Allow a 6" (15 cm) clearance
around the drive for cooling.
Use the holes and
guides provided.
(DO NOT drill holes
in the drive.)
GND
3