Hamamatsu PDE C9830 Manuel D'utilisation page 10

Safety Precautions
Shipping precautions
When transporting the device by truck, ship, airplane, etc., be sure it is securely packaged in the
original packaging material or something similar.
Mechanical shocks
Do not subject the device to strong shocks by dropping it, for example. Doing so can damage the
device. The front part of the Camera Unit, which is equipped with optical components, is particu-
larly susceptible to mechanical shocks.
Avoid using or storing this system in the following places:
Where the ambient temperature might fall below 0 °C or rise above 40 °C.
•
Where the temperature varies extremely.
•
In direct sunlight or near a heater.
•
Where the humidity is 70 % or more or where there is dripping water.
•
Close to a strong source of magnetism or electromagnetic waves.
•
Where there is vibration.
•
Where it might come into contact with corrosive gases (such as chlorine or fluorine).
•
Where there is a lot of dust.
•
Do not allow the ventilation ports to become blocked.
To prevent overheating in the device, do not wrap the Controller in cloth or other material, or allow
the ventilation ports of the power supply unit to become blocked in any way.
If the system is being operated in an enclosed environment, ensure clearance of at least 10 cm
from both the inlet and exhaust vents when setting up the system.
Vapor condensation on the camera window
When the PDE is brought into a cold room from a warm place, vapor may condense on the cam-
era window and make the observed image foggy. Wait to operate the PDE until after the image
becomes clear.
Page 1-8
CAUTION
Instruction Manual PDE
Version 1.30E